clarinet in A tuner
An online A clarinet tuner analyzes the sound captured by your microphone and shows whether each written note is flat, sharp, or in tune. Tune your A clarinet directly in your browser with this free chromatic tuner: allow microphone access, play one steady note, and follow the indicator until it stays centered.
Metronaut is already transposed for A clarinet, so the tuner follows the notes written in your clarinet part. Play written C and the display shows C; that note produces concert A, with no conversion needed on this page.
To tune your instrument, allow microphone access when your browser asks.
Reference frequency used for tuning
Your instrument is in tune. Start playing.
Once your instrument is in tune, continue with Metronaut’s interactive sheet music and professional accompaniments. Slow down the tempo, transpose a piece, repeat difficult passages in a loop and get feedback on whether you are playing the right notes.

How to read the A clarinet tuner
The diagram compares the three main tuner states. Read the displayed note as the note written in your A clarinet part, then keep a steady sound and adjust until the cursor stays centered.
Check the displayed note
Play one sustained note and check that the display matches your A clarinet part. Written C should appear as C on this page.Centered means in tune
The written note is in tune when the cursor stays centered while your sound remains steady.Cursor on the left: pitch too low
The note sounds lower than the target note. Keep the sound stable, then raise the pitch using the tuning steps below.Cursor on the right: pitch too high
The note sounds higher than the target note. Keep the sound stable, then lower the pitch using the tuning steps below.If the note jumps around
Hold one note in a quiet room. Check the reed, air support, and microphone pickup before changing the instrument.
How to tune an A clarinet online
- 1
Warm up and prepare a stable note
Play for a few minutes before making final adjustments. Choose a responsive reed, move to a quiet place, and keep the microphone uncovered. - 2
Start with written C
Play written C and wait for the tuner to stay centered on C. When an orchestra gives concert A, this is the corresponding written note for A clarinet. - 3
Adjust the barrel first
If the clarinet is sharp, pull the barrel out slightly to lower the pitch. If it is flat, push the barrel in slightly to raise it. Recheck after every small movement. - 4
Keep joint changes very small
If barrel adjustment is not enough, ask a teacher or technician before changing the upper or lower joint gaps. Uneven or large gaps can affect response and intonation. - 5
Keep air and embouchure consistent
Maintain the same air support, volume, and embouchure while checking each note. Do not bite or loosen the embouchure just to force a centered reading. - 6
Check written G and both registers
After written C is centered, check written G and several notes across the chalumeau and clarion registers. Recheck after long rests or instrument changes.
The tuner follows written notes for A clarinet
A clarinet is a transposing instrument: written C produces concert A, a minor third lower. Metronaut handles this automatically, so the display follows the note names in your A clarinet part.
Tune from those written note names. Concert-pitch conversion only matters when comparing with a piano, flute, or a tuner that has not been set for A clarinet.
A clarinet tuning references
Written C
Check this note when an orchestra gives concert A. The Metronaut tuner should show C when your written C is centered.Written G
Written G produces concert E. Play it after the main tuning note to check response and stability elsewhere on the instrument.Chalumeau and clarion registers
Compare low and higher notes because clarinet intonation can vary between registers.A clarinet versus B-flat clarinet
The instruments share written fingerings, but the A clarinet sounds one semitone lower than the B-flat clarinet. Select the tuner page that matches the instrument in your hands.
A clarinet tuning tips
Start with a responsive reed
A reed that is too soft, too hard, dry, damaged, or worn can make the pitch unstable. Wet, reseat, or replace it before changing the instrument.Check reed and ligature placement
Center the reed on the mouthpiece and secure the ligature without overtightening. Poor alignment can make the note slow to speak or difficult to hold.Recheck after switching clarinets
If you move between B-flat and A clarinet, let the A clarinet warm up and test it again instead of assuming the same barrel position will be correct.Do not chase every flicker
Let the note speak clearly and hold it before deciding whether the clarinet is flat or sharp.Diagnose differences between registers
If low and higher notes disagree, check voicing, reed setup, and embouchure before moving the barrel or joints again.Know when the issue is not overall tuning
If one note remains unusually sharp or flat while the others center, a pad leak or mechanical adjustment may be involved. Ask a teacher or repair technician to check it.