french horn tuner
An online French horn tuner analyzes the sound captured by your microphone and shows whether each written note is flat, sharp, or in tune. Tune a French horn directly in your browser with this free chromatic tuner: allow microphone access, play one steady note, and follow the indicator until it stays centered.
Metronaut is already transposed for French horn in F, so the display follows the notes written in your part. Play written C and the display shows C; that note produces concert F.
To tune your instrument, allow microphone access when your browser asks.
Reference frequency used for tuning
Your instrument is in tune. Start playing.
Once your instrument is in tune, continue with Metronaut’s interactive sheet music and professional accompaniments. Slow down the tempo, transpose a piece, repeat difficult passages in a loop and get feedback on whether you are playing the right notes.

How to read the French horn tuner
The diagram compares the three main tuner states. Read the displayed note as the note written in your French horn part. Keep a steady sound and adjust until the cursor stays centered.
Check the displayed note
Play one sustained written note and confirm that the tuner identifies that written note, not its concert-pitch equivalent.Centered means in tune
Keep the air stream steady. The note is in tune when the cursor remains centered.Cursor on the left: pitch too low
The note sounds lower than the target note. Push the main tuning slide in slightly to shorten the tubing and raise the overall pitch.Cursor on the right: pitch too high
The note sounds higher than the target note. Pull the main tuning slide out slightly to lengthen the tubing and lower the overall pitch.If the reading jumps
Move closer to the microphone, clear condensation, play without vibrato, and wait for the note to settle.
Adjust the French horn's main tuning slide
Warm up for a few minutes, then play one steady reference note. If the tuner consistently shows that the French horn is sharp or flat, adjust the main tuning slide—the U-shaped section inside the central coil highlighted in orange.
Move it only a few millimeters at a time, then play the same note again. On a double horn, set the main tuning slide before fine-tuning the F side separately.
Sharp — pull the slide out
This lengthens the tubing and lowers the pitch.Flat — push the slide in
This shortens the tubing and raises the pitch.In tune — leave it in place
No slide adjustment is needed.
The tuner follows written notes for French horn
French Horn is a transposing instrument in F: written C produces concert F, a perfect fifth lower. Metronaut handles this automatically, so the display follows the written note names in your part.
Tune from those written note names. Concert-pitch conversion only matters when comparing with a piano or a tuner that has not been set for French horn.
French Horn tuning references
Written C
Sounds concert F; the tuner displays C.Written F
Sounds concert B-flat; the tuner displays F.Written G
Sounds concert C; the tuner displays G.
French Horn tuning tips and common problems
Keep the right hand position consistent
Moving the right hand farther into or out of the bell changes pitch and tone. Use your normal hand position for every tuning check.Warm the instrument thoroughly
Long tubing takes time to reach playing temperature. Recheck after rests and during long rehearsals.Check both sides of a double horn
A centered main note does not guarantee that the F and B-flat sides are balanced. Compare both sides using the tuning procedure for your horn.Use steady air without forcing
Avoid changing embouchure pressure just to center the display; that can hide a slide or setup problem.Inspect persistent patterns
Sticky rotors, leaks, dents, or poorly seated slides need attention from a teacher or repair technician.