violin tuner
An online violin tuner analyzes the sound captured by your microphone and shows whether each open string is flat, sharp, or in tune. Tune your violin directly in your browser with this free chromatic tuner: allow microphone access, play one open string, and follow the indicator until it stays centered.
This page is designed for standard violin tuning in fifths: G3, D4, A4 and E5, from lowest to highest.
To tune your instrument, allow microphone access when your browser asks.
Reference frequency used for tuning
Your instrument is in tune. Start playing.
Once your instrument is in tune, continue with Metronaut’s interactive sheet music and professional accompaniments. Slow down the tempo, transpose a piece, repeat difficult passages in a loop and get feedback on whether you are playing the right notes.

How to read the violin tuner
The diagram shows the tuner's three main states. Play one open string at a time, check that the displayed note matches it (G, D, A, or E), then adjust the string until the cursor stays centered.
Play an open string
Play one open string at a time and check that the displayed note matches the string: G, D, A, or E.Centered means in tune
The string is in tune when the cursor stays centered and the displayed note remains stable.Cursor on the left: pitch too low
The string is below the target pitch. Keep the note steady, then raise the pitch using the tuning steps below.Cursor on the right: pitch too high
The string is above the target pitch. Keep the note steady, then lower the pitch using the tuning steps below.If the wrong note appears
The string may be far from the target pitch, or another string may still be ringing. Mute the other strings, play the same open string again, and adjust slowly until the expected note appears.
How to tune a violin with the online tuner
- 1
Prepare a clean sound
To tune your violin accurately, choose a quiet place, keep your device microphone uncovered, and play one open string at a time. Let the string ring long enough for the tuner to stabilize. - 2
Start with A
Tune A first, then continue with D, G and E. This matches the way most lessons, rehearsals and ensembles begin tuning. - 3
Adjust with the right control
Fine tuners are the small screws on the tailpiece, below the bridge. They work best when the string is close to pitch. The pegs sit in the pegbox, just below the scroll, and are for larger corrections. Move either control in very small steps. - 4
Check the whole violin again
Adjusting one string can slightly affect the others. Recheck G, D, A and E before you start practicing.
Tune each violin string
The diagram identifies each string before you play it into the microphone. From lowest to highest pitch, violin strings are G, D, A and E.
Tune one open string at a time. Start with A as your reference, continue with D, G and E, then recheck the whole violin at the end.
Standard violin string notes
G string: G3
G is the lowest violin string. Raise the pitch gently, especially if a peg adjustment is needed.D string: D4
D sits between G and A. Adjust gradually and let the string ring long enough for the tuner to stabilize.A string: A4
A is the usual reference string for violin tuning and for most ensemble tuning.E string: E5
E reacts quickly to small changes. Fine tuner adjustments work best when the pitch is already close.
Violin-specific tuning tips
Protect the strings
Violin strings are under tension. Raise the pitch slowly and stop if a string feels unusually tight.Handle pegs carefully
If a peg slips back, press it gently inward while turning. If it still slips or feels stuck, ask a teacher or luthier instead of forcing it.Tune in playing position
Hold the violin in a stable playing position when possible. This gives the microphone a consistent sound and keeps the instrument secure while you adjust it.Reset fine tuners when needed
If a fine tuner reaches the end of its travel, loosen it back toward the middle and make the larger correction with the peg.Recheck after changes
New strings, travel, humidity and temperature changes can make a violin drift out of tune. A quick recheck before practice is normal.Watch the bridge
Large tuning changes can pull the bridge slightly toward the fingerboard. If it looks tilted, stop adjusting and ask a teacher or luthier to check it instead of forcing it back.